From 02e8142b6df146272bdcaba6d7f481061540cebe Mon Sep 17 00:00:00 2001 From: Gibheer Date: Tue, 11 Dec 2018 13:44:03 +0100 Subject: extend the README with a configuration section This section should give a short introduction on how to configure the system. There should be a frontend to do the same thing later. --- README.md | 47 +++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 47 insertions(+) diff --git a/README.md b/README.md index 40f0987..8628e31 100644 --- a/README.md +++ b/README.md @@ -40,3 +40,50 @@ It is responsible to cleanup the history and generate the configuration. The configuration is generated into `active_checks` when an entry in `nodes`, `command` or `checks` was changed (detected through the updated column). + +configuration +------------- + +To get the system working, first install the database. After that, create an +alarm mapping: + +``` +insert into mappings(name, description) values ('default', 'The default mapping'); +insert into mapping_level values (1, 0, 0, 'okay', 'green'); +insert into mapping_level values (1, 1, 1, 'okay', 'orange'); +insert into mapping_level values (1, 2, 2, 'okay', 'red'); +insert into mapping_level values (1, 3, 3, 'okay', 'gray'); +``` + +Next is to create a notifier. This feature doesn't work 100% yet and needs some +work and may look different later: + +``` +insert into notifier(name) values ('default'); +``` + +After that create a check command: + +``` +insert into commands(name, command, message) values ('ping', 'ping -n -c 1 {{ .ip }}', 'Ping a target'); +``` + +This command can contain variables that are set in the check. It will be executed by moncheck and the result stored. + +After that, create a node which will get the checks attached: + +``` +insert into nodes(name, message) values ('localhost', 'My localhost is my castle'); +``` + +With that prepared, create the first check: + +``` +insert into checks(node_id, command_id, notifier_id, message, options) +values (1, 1, 1, 'This is my localhost ping check!', '{"ip": "127.0.0.1"}'); +``` + +Now start the daemons moncheck, monfront and monwork. + +monwork will transform the configured check into an active check, while moncheck +will run the actual checks. Through monfront one can view the current status. -- cgit v1.2.3-70-g09d2